Where is DLP Agent Installation Media?

I have just installed an Endpoint server.  No policies have been configured yet.

Can the agents be deployed to endpoint computers with no polices configured just to get the software out to them and then configure policies later?

I only see the detection server installation software in our downloads.

The Admin Guide says:

Installing the Symantec Management Agent

You must install the Symantec Management Agent before you install the Symantec

DLP Agent. The Symantec Management Agent and the Symantec DLP Agent run

concurrently on your endpoint computers. The Symantec Management Agent lets

you deploy the Symantec DLP Agent. It also lets you use a number of

troubleshooting agent tasks.

Implementing Symantec DLP Agents 1355

About the Symantec Management Console

Note: In Symantec Data Loss Prevention v11.x, SMP v7.0 and SMP v7.1 are

supported.

Installing the Symantec Management Agent

1 From the DLP Portal page click the Install Symantec Management Agent

link.

2 Click the SelectComputers option and select the specific endpoint computers

where you want the Symantec Management Agent installed.

3 Click the Install Symantec Management Agent option.

4 Click Proceed with Install. The installation starts immediately.

Note: If you want to set the installation on a schedule, click Installation

Settings and modify the settings in the pop-up window.

After you have installed the Symantec Management Agent, you can install the

Symantec DLP Agent